unable to set phy[1].fmin to 4700
I’m replying “Low-cost DIY underwater modem using COTS components and Unet audio” but when I set:
unable to set phy[1].fmin to 4700
I’m replying “Low-cost DIY underwater modem using COTS components and Unet audio” but when I set:
unable to set phy[1].fmin to 4700
I’m replying “Low-cost DIY underwater modem using COTS components and Unet audio” but when I set:
How to transmit a file located in an arbitrary path using: RemoteFilePutReq
I’m working on sending a file from one node to another using the Remote service in Python:
How to use “preamble” and “basebandRx” in MATLAB to transmit baseband signals in unetstack?
I referred to this blog post, “Using MATLAB with UnetStack3” ([https://blog.unetstack.net/using-matlab-with-unetstack3][1]), and added a preamble at the transmission part:
How to use “preamble” and “basebandRx” in MATLAB to transmit baseband signals?
I referred to this blog post, “Using MATLAB with UnetStack3” ([https://blog.unetstack.net/using-matlab-with-unetstack3][1]), and added a preamble at the transmission part:
What does ‘Noise’ refer to in the Acoustics module?
I don’t quite understand what ‘Noise’ refers to here.
Is it the magnitude of noise added by Unet Audio to the transmitted signal, or is it the magnitude of ambient noise detected by my modem?Can the ‘Noise’ parameter be modified?
What dose it means when the dashboard of Channel(1-3) turns red?
While using Unetstack, I suddenly noticed that the Channel(1-3) interface on the localhost web page turned red. What could be the problem?
Here is the image:
