I have the following problem, I have a population of agents living in the main agent. Now, the agent has two parameters longitude and latitude. The values of longitude and latitude vary between 56.88, 56.99 and -5.688, -5.788.

I have a population of agents living in the main agent. These agents have two parameters using Latitude and Longitude, which is defined by uniform(… , …) on startup code in agent.

I have Person agent in GIS space and 3 facilities. Which person will go to which facility is determined outside of simulation (an attribute in Person ‘facilityChoice’). For three facility I drew 3 process flow source -> moveTo -> queue -> delay -> sink. At each source, only the people specific to that facility are entering. Question: HOW CAN I CONTROL ARRIVAL RATE? The person agent has one attribute ‘age’. I want to control the arrival rate based ‘age’. For instance, if age is 65, arrival rate will be 5 per minute, if age is 20 then 1 per minute, and so on. Below is a model snapshot.

I’m working on implementing a line of sight/vision cone in Anylogic and I’ve hit a couple roadblocks. My primary question is how to get agents to provide contacts with a node inside another agent, but I’ll also show the other attempts I tried and gave up on in case those have more merit.

I have implemented a custom Genetic Algorithm and want to run my simulations that are in the same generation parallel with one another. For my specific use case, I could not use the in-built Optimisation Experiment as I had to define over 1500 parameters if I do so.

I’m trying to calculate the distance between two nodes but I can’t find a solution:

I’m doing a project for a company producing wafers. The goal is to try to find a way to predict the impact off different problems on the wafer final testing step. To do so I’ve imagine a model with 5 different type of wafer (Wafer1, Wafer2, Wafer3…) and 5 different types of testers (Tester1, Tester2, Tester3…). Each tester will be able to test some, but not all, type of wafer.

Does anyone knows how can I create a logic as Select Output In/Select Output Out using FluidSelectOutput or something like that that works for Fluid Library?

In AnyLogic, I have a custom agent called ‘Slab’. I’ve created an agent population using this agent, where an event creates a ‘Slab’ agent every 3 minutes, labeled as S0, S1, S2, and so on. When these slabs stack, I can control the stacking order by setting the z-value so that the later generated agent, S2, appears on top of the earlier generated agent, S0. However, in the 2D view, S0 still appears on top. How can I make S2 display above S0 in the 2D view?
anylogic 2D and 3D view

I have tried installing Anylogic 8.2/8.3/8.4 however not able to launch the Anylogic SW. Each time I launch I get check error message with below error: